This guide is intended for a pilot who has already setup his helicopter to
his liking and understands how to correctly adjust a CCPM helicopter.
Newer pilots are recommended to use the other guides.
| Step 1 | Remove the bolt holding the head block onto the main shaft and the four links on the inside of the swash plate. |
| Step 2 | Remove the head from your helicopter and slide the swash plate leveler onto the helicopter. |
| Step 3 | Set the collective stick to center and adjust your links until all 3 points of the swash plate touch the leveling tool. |
| Step 4 | Lower
the collective stick to bottom and check the swash plate against the
leveling tool. If its not level adjust this with your Transmitter CCPM
ATV values. |
| Step 5 | Raise the collective
stick to the top and again check the swash plate for being level.
Adjust the CCPM ATV values until the swash is touching the 3 points of
the leveling tool. |
| Step 6 | Put the head back onto the main shaft, connect the ball links and replace the head bolt. |
| Step 7 | Your finished, go fly. Don't forget to not add trim to your helicopter, it will only disrupt the leveling you have just done. |
Copyright © by Trueblood Engineering All Right Reserved.
